Introduction

The two-area system used is example 12.6 at page 813 in the textbook "Power System Stability and Control", written by Prabha Kundur [1].

The basic topology is depicted in Figure 1.

Figure 1. Single line diagram of of Kundur's Two-Area System

The system contains eleven buses and two areas, connected by a weak tie between bus 7 and 9.

Totally two loads are applied to the system at bus 7 and 9.

Two shunt capacitors are also connected to bus 7 and 9 as shown in the Figure 1.

The system has the fundamental frequency 60 Hz.

It is recommended to run the training cases and read the textbook in parallel since the training follows pages 813 - 816.

The system comprises two similar areas connected by a weak tie.

Each area consists of two generators, each having a rating of 900 MVA and 20 kV..

You can send submissions, questions and requests to fglongatt@fglongatt.org.ve.

[1] M. Klein, G.J. Rogers, and P. Kundur: "A Fundamental Study of Inter-Area Oscillations", IEEE Trans., Vol. PWRS-6, No. 3, pp. 914-921, August, 1991.

[2] Prabha Kundur: "Power System Stability and Control", The EPRI Power System Engineering Series, 1994, McGraw-Hill, ISBN 0-07-035958-X.

-- IMPORTANT -- Material in the archive is intended for purposes of research and education, not for commercial gain.

tEST cASES Single-Line diagram of of Kundur's Two-Area System (86KB JPEG) (Small readable version) IEEE Common Data Format (CDF) [.txt File] DIigSILENT PowerFactory [Download] Powerworld [Download] Power System Toolbox (PST) [Donwload [Donwload] Power System Analysis Toolbox (PSAT) [Download]